Oil and Gas
Here are a few examples of projects completed by GCM in the Oil and Gas sector.

Project
Installation of an air preheater on the crude unit's kiln ($11 M)
GCM's mandate
Preliminary and detailed engineering
Read about this project
Project
Pump House Reshaping
GCM's Mandate
Preliminary Engineering ± 30 %
Detailed Engineering

Project
Rail Car Loading Rack
GCM's Mandate
Engineering, Procurement and Construction Management
Read about this project
Project
Major repairs and modifications in the sulphuric acid tank area
GCM's Mandate
Preliminary and Detailed Engineering
Read about this project
Project
Catalytic Cracker Flue Gas Waste Heat Boiler Replacement
GCM's Mandate
FEED and Preliminary and Detailed Engineering
Read about this project
Project
Furnace Burner Management System (BMS) Upgrade
GCM's Mandate
Engineering, Procurement and Construction Management
Read about this project
Project
Biomass Centrifuge Upgrade. The main objective was to investigate current operation conditions to identify the main causes of the unreliability of this operation. In addition, the centrifuge’s location needed to be reviewed.
GCM's Mandate
Conceptual study
Read about this project
Project
Following the conversion of a Once Through Steam Generator from a sweet to a mixed sour gas service, the exhaust stack sustained severe corrosion and failed three times since its installation.
GCM's Mandate
Redesign the stack to eliminate the root causes of failure and allow continued long-term service.
Read about this project
Project
Factory production capacity increase by improving the pre-heat trains and installing new pumps, vessels, racks and electrical power supplies.
GCM's Mandate
Engineering and construction management support
Read about this project
Project
Allow the unloading of petroleum products (jet fuel, diesel, furnace oil) from pier to distribution center
GCM's Mandate
Multidisciplinary detailed engineering
Read about this project
Project
Construction of two new solvent tanks at an asphalt refinery. Pumping and distribution system for shipment by truck or rail.
GCM's Mandate
Multidisciplinary engineering
Read about this project
Project
Enlargement of an existing electrical room for the replacement of a 4.16 kV switchgear by two 4.16 kV switchgears to permit greater flexibility and reliability. This project included coordination with an architect, the engineering for the electrical feed of the new switchgears, the electrical distribution of the building expansion, the new cable trays, the transfer of the existing loads to the new switchgears, the electrical studies.
GCM's Mandate
Multidisciplinary engineering
Read about this project
Project
Burner Management System Upgrade
GCM's Mandate
Engineering and Construction Management
Read about this project
Project
Construction of a new blast-resistant Control Room
GCM's Mandate
Detailed Engineering, Procurement, Project Management and Construction Supervision
Read about this project
Project
Installation of a new deluge system to protect eight polymerisation reactors. The project also required the capacity to cover a total of 5 deluge zones
GCM's Mandate
Multidisciplinary detail engineering works for the design of the foundation, the prefab building, the fire water header (5 zones), the piping, spray nozzle pattern and system automation
Read about this project
Project
Expansion of a heavy oil battery whereby emulsion treating and water disposal capacity were increased by over 200%.
GCM's Mandate
Preliminary Engineering and Cost Estimate (+/- 25%)
Read about this project
Industry sectors
Oil and Gas Chemical and Petrochemical Mining and metals Renewable Energy Manufacturing Pharma, Biotech and Food Environment and Sustainable DevelopmentYou want to be a part of our team?
We are always looking for new talent!
See the available offers
OR
Send a
personalized application